At Smart Family of Cooling Products, we want to provide our customers with the most relevant and up to date information available. With this in mind, we wanted to include easy to access start-up videos for the ERS CAT Sales & Service team.

This particular video demonstrates the start-up of our 30 ton Industrial Air Cooled Air Conditioning Unit (SACP30A-HS). We appreciate you taking the time to watch and we hope this is a helpful tool for the ERS CAT team.

Start-up for ERS CAT 30 Ton AC Unit

OPERATOR INSTRUCTIONS

STEP 1: Confirm that circuit breaker (8CB) is switched ON and CONTROL POWER pushbutton light (1PL) is lit.
• If not, check phase monitor relay (PMR) and emergency stop (ES) button.
• If INCORRECT POWER pushbutton light (2PL) is lit, check PMR for phase rotation and voltage setting.

STEP 2: Turn ON AIR FLOW switch (1SW).

STEP 3: Turn BLOWER switch (2SW) to require blower operating mode.
• VFD RUNNING pushbutton light (3PL) lit if blower is started using VFD.
• BYPASS RUNNING pushbutton light (5PL) lit if blower is started using bypass starter.
• Check blower circuit breaker overload (4OL) or VFD status if BLOWER TRIP pushbutton light (4PL) is lit.

STEP 4: Set blower running speed using SPD ADJ POT (potentiometer)

STEP 5: Cooling probe selection switch (4SW) and heating probe selection switch (8SW)
• Turn 4SW to ENT – Cooling is based on entering air control.
• Turn 4SW to LVG – Cooling is based on leaving air control.
• Turn 8SW to ENT – Heating is based on entering air control.
• Turn 8SW to LVG – Heating is based on leaving air control.

STEP 6: Turn OFF/CLG/HTG/DH switch (5SW) to require unit operating mode.
• Turn 5SW to OFF – Unit is switched off.
• Turn 5SW to CLG – Unit is running in cooling mode.
• Turn 5SW to HTG – Unit is running in heating mode.
• Turn 5SW to DH – Unit is running in dehumidification mode.

STEP 7: Turn OFF/LOCAL/HAND/REMOTE switch (3SW and/or 6SW & 7SW) to require compressor and/or heater operating mode.
• OFF – Switched off.
• LOCAL – Operating with local controller.
• HAND – Operating in manual mode without the controller (manual on).
• REMOTE – Operating in remote mode without the controller (on/off by remote thermostat)

It is the customer’s responsibility to always follow the written operating instructions of the unit and maintain safe work practices.